Notifications
Clear all
jeffrey.r10
jeffrey.r10
Group: Registered
Joined: 2019/04/22
Eminent Member
2
@gnat Again, thank you for these tips. I truly hope they wi...

In forum General discussion, announcements and releases

1 year ago
I should correct myself. It did help with fat tips, but did...

In forum General discussion, announcements and releases

1 year ago
@gnat Agreed. But that replacement was one of the first thi...

In forum General discussion, announcements and releases

1 year ago
@nikolai-r Sorry, I have to completely disagree with nikolai...

In forum General discussion, announcements and releases

1 year ago
I appreciate the attempt to help. I really do. Your mod co...

In forum General discussion, announcements and releases

2 years ago
An interesting idea. But I measured the extruder motor and ...

In forum General discussion, announcements and releases

2 years ago
@ruben-w Sorry, its the threads that are screwing me up, not...

In forum General discussion, announcements and releases

2 years ago
I fully agree with the original post. Prusa should pull thi...

In forum General discussion, announcements and releases

2 years ago
@volker-h3 That was an excellent post. Thanks. You inspired...

In forum General discussion, announcements and releases

2 years ago
@volker-h3 Thank you again for some good suggestions. This ...

In forum General discussion, announcements and releases

2 years ago
I think I've tried 50 combinations of cooling moves and ramm...

In forum General discussion, announcements and releases

2 years ago
Thanks. I did finally get through to someone and they are s...

In forum Hardware, firmware and software help

2 years ago
Thanks nikolai. I tried to post a question last night, but ...

In forum Hardware, firmware and software help

2 years ago
Dead FINDA

In forum Hardware, firmware and software help

2 years ago
Yes, the test is from real tool changes. I have a test prin...

In forum General discussion, announcements and releases

2 years ago
@oliver-r4 Thanks for the suggestion. You motivated me to t...

In forum General discussion, announcements and releases

2 years ago
So after a couple more weeks of experimenting, I am no close...

In forum General discussion, announcements and releases

2 years ago
@michael-t66 Thank you for the explanation. I tried a couple...

In forum General discussion, announcements and releases

2 years ago
@michael-t66 I'm not sure I understand what you mean about t...

In forum General discussion, announcements and releases

2 years ago
update: printing PLA at 210 caused a jam (the eSun filament ...

In forum General discussion, announcements and releases

2 years ago
Page 1 / 2
Share: