Activity
 
Notifications
Clear all
Dave G
Dave G
Group: Registered
Joined: 2019/04/21
Eminent Member
2
This is even worse in 2.3.1 because now you can't optimize o...

In forum PrusaSlicer

6 months ago
I just realized the U bolt replacements aren't printed parts...

In forum General discussion, announcements and releases

8 months ago
Y Carriage part replacements with MK3S+ parts?

In forum General discussion, announcements and releases

8 months ago
Yeah could definitely be that too, might just replace both I...

In forum Hardware, firmware and software help

8 months ago
Thermal runaways all of a sudden

In forum Hardware, firmware and software help

8 months ago
@neophyl Yes, I did do that.

In forum PrusaSlicer

9 months ago
Same issue here, this is very problematic and a terrible cha...

In forum PrusaSlicer

9 months ago
@jeremyprops Yeah actually I did. Turns out there was a tin...

In forum Hardware, firmware and software help

2 years ago
@jeremyprops Yeah actually I did. Turns out there was a tin...

In forum Hardware, firmware and software help

2 years ago
Yeah no luck. Support suggested a motor swap with the X-Axi...

In forum Hardware, firmware and software help

2 years ago
Didn't see anything when I had the heated bed off but I'll t...

In forum Hardware, firmware and software help

2 years ago
Phantom Y Crashes

In forum Hardware, firmware and software help

2 years ago
Huge thanks to Jakub on the support line. Found some filame...

In forum Hardware, firmware and software help

2 years ago
Support suggested lubrication which I just tried. Still thr...

In forum Hardware, firmware and software help

2 years ago
Y-Axis length error and inconsistent resistance

In forum Hardware, firmware and software help

2 years ago
Considering moving up from the Photon S

In forum General discussion, announcements and releases

2 years ago
Seems to be a bit better, I pulled off the upper supports fo...

In forum Hardware, firmware and software help

2 years ago
Okay that makes sense. I'll pull that apart tonight. My sec...

In forum Hardware, firmware and software help

2 years ago
Okay so the smooth rods seem to have a little vertical play,...

In forum Hardware, firmware and software help

2 years ago
Peepholes, hmmm.... I'll take a close look, just got home....

In forum Hardware, firmware and software help

2 years ago
Page 1 / 2
Share: