Activity
 
Notifications
Clear all
Zoltan
Zoltan
Group: Moderator
Joined: 2019/04/01
Moderator
3
Je to jen na vás uzivatelích. 😉 já to jen oznamuji.

In forum Hardware, firmware a software (Pomoc)

3 days ago
Musis velmi peclive doladit oba snimace filamentu jak na tis...

In forum Složení tiskárny a řešení potíží s prvním tiskem

7 days ago
The color change slider is visible after the initial slicing...

In forum How do I print this? (Printing help)

1 week ago
Congratulation to you success. Now you are dealing with firs...

In forum Hardware, firmware and software help

2 weeks ago
Dokud podrobněji nenapíšeš co všechno si dělal a co ti napsa...

In forum Složení tiskárny a řešení potíží s prvním tiskem

2 weeks ago
Before multicolor print use the command load all ,this will ...

In forum Assembly and first prints troubleshooting

3 weeks ago
Make sure you have the sensors correctly calibrated. The pri...

In forum Assembly and first prints troubleshooting

3 weeks ago
Not sure they follow the sun, but I would guess at 8 am US e...

In forum Hardware, firmware and software help

4 weeks ago
Do you have correctly set the 1-st Layer calibration?

In forum Hardware, firmware and software help

4 weeks ago
Asi bys měl napsat z čeho tisknes (filament ) na čem tisknes...

In forum Jak to vytisknu? (Pomoc s tiskem)

1 month ago
Infil není třeba, problém vyřeší podpěry nejlépe vynucené- v...

In forum Jak to vytisknu? (Pomoc s tiskem)

1 month ago
Did you touch anything inside the box or did any changes on ...

In forum Hardware, firmware and software help

1 month ago
You can check the prusa git site, there is probably a featur...

In forum Hardware, firmware and software help

1 month ago
The best way having the printer under warranty to contact su...

In forum Hardware, firmware and software help

1 month ago
This not an x axis test failure 😉 but mash bed leveling issu...

In forum Hardware, firmware and software help

1 month ago
Can you please describe in more details what exactly means "...

In forum Hardware, firmware and software help

1 month ago
Pokud se materiály neslepí, pak je potřeba nadesignovat mech...

In forum Obecná diskuze, oznámení a novinky

1 month ago
Did you succeed ať least with one print? Does during test of...

In forum Hardware, firmware and software help

1 month ago
Darrick, Can you provide the x axistest.txt file from usb st...

In forum Hardware, firmware and software help

1 month ago
Page 1 / 69
Share: