Notifications
Clear all
huskyte
huskyte
Group: Registered
Joined: 2019/03/15
Trusted Member
3
Ok, common problem. It's your idler sensor. Although I have ...

In forum Hardware, firmware and software help

1 day ago
ok, just my 2cts for that discussion as I own both kinds: De...

In forum General discussion, announcements and releases

4 months ago
@boatbuilder I just wanted to share my experience, becuase y...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
@meat_aggressor Looks great and a bit familiar if I might sa...

In forum User mods - OctoPrint, enclosures, nozzles, ...

7 months ago
Quite interesting. If I am not mistaken the ordering page of...

In forum General discussion, announcements and releases

11 months ago
@mractor1 it happened in the past, even to me, but that isn'...

In forum Hardware, firmware and software help

2 years ago
@mractor1 Hi there, you need to make sure the lever of the e...

In forum Hardware, firmware and software help

2 years ago
Had another closer look: I wasn't really aware that higher t...

In forum How do I print this? (Printing help)

2 years ago
@claand Also from Switzerland. I basically rely on Fillament...

In forum General discussion, announcements and releases

2 years ago
@robert-rmm200 Ok, checked it out. Got a better picture now....

In forum How do I print this? (Printing help)

2 years ago
@jeffrey-r10 Sorry, I couldn't catch up on all of the thread...

In forum General discussion, announcements and releases

2 years ago
@adam-m43 No problem at all. I'll try to elaborate it furthe...

In forum Hardware, firmware and software help

2 years ago
@anthony_davis Same here: The moment it was all figured out ...

In forum Assembly and first prints troubleshooting

2 years ago
@kumters Lowering the retraction might help to mitigate the ...

In forum Assembly and first prints troubleshooting

2 years ago
@karl-herbert thx for the inspiration. As I cannot edit my o...

In forum Hardware, firmware and software help

2 years ago
@kumters ok, a bit of a search riddle: It is one of those b...

In forum Hardware, firmware and software help

2 years ago
@kumters By the way, had this in an enclosure down to 22-24 ...

In forum Assembly and first prints troubleshooting

2 years ago
@kumters I would still check for heat creep. Look at one of ...

In forum Assembly and first prints troubleshooting

2 years ago
@jeffrey-r10 Again, this is heat creep and nothing else. You...

In forum General discussion, announcements and releases

2 years ago
@bestellung PETG? Which temperature? With PETG I personally ...

In forum General discussion, announcements and releases

2 years ago
Page 1 / 4
Share: