Activity
 
Notifications
Clear all
Rick
Rick
Group: Registered
Joined: 2019/03/08
Trusted Member
3
The purge is likely a single instruction to feed some mm of ...

In forum Hardware, firmware and software help

6 months ago
I tried another USB drive and it worked. The one that wasn’t...

In forum Hardware, firmware and software help

8 months ago
I'm having the same issue. I put the new .bbf file on my USB...

In forum Hardware, firmware and software help

8 months ago
If a firmware update doesn’t work for you, go back to the ve...

In forum General discussion, announcements and releases

9 months ago
I shutter to think what your power supply might be overheari...

In forum General discussion, announcements and releases

9 months ago
Roll back to 3.9.2 and see if that resolves the issue.

In forum General discussion, announcements and releases

9 months ago
Submitted a bug report in Github. [BUG] File select from S...

In forum General discussion, announcements and releases

9 months ago
Finished the build of my new MK3S+ and printed the Marvin wh...

In forum General discussion, announcements and releases

9 months ago
I think the way you do this is to print your part, use that ...

In forum General discussion, announcements and releases

11 months ago
Typically the part cooling fan doesn’t run during the first ...

In forum General discussion, announcements and releases

11 months ago
They said that upgrade kits would be available in January. R...

In forum Hardware, firmware and software help

11 months ago
Ordered my kit on 22-Jun and it shipped today. No extras. Sp...

In forum General discussion, announcements and releases

1 year ago
Print fan error

In forum Assembly and first prints troubleshooting

1 year ago
@some-dude Thanks but I’m waiting for my MK3S kit. Ordered o...

In forum General discussion, announcements and releases

1 year ago
Looking at the orders spreadsheet, which may be less than ac...

In forum General discussion, announcements and releases

1 year ago
Yes but moisture in the filament should cause random imperfe...

In forum Assembly and first prints troubleshooting

1 year ago
I suspect the main focus when they hire programmers is that ...

In forum General discussion, announcements and releases

1 year ago
RE: SERIOUS PROBLEM WITH "GAP FILL"

In forum General discussion, announcements and releases

1 year ago
The question is, what did you order compared to the other or...

In forum General discussion, announcements and releases

1 year ago
Factory reset?

In forum Hardware, firmware and software help

1 year ago
Page 1 / 5
Share: