holmes4
holmes4
Group: Registered
Joined: 2019/02/28
Estimable Member
4
@mvdh I agree, but if you don't want to edit the firmware so...

In forum Hardware, firmware and software help

2 months ago
If you go to the link posted above, the page says that the p...

In forum General discussion, announcements and releases

6 months ago
@jsw It's a BIT less if you buy through PandaPi.

In forum General discussion, announcements and releases

6 months ago
Recommended motors are in the "readme" at the github page (s...

In forum User mods - OctoPrint, enclosures, nozzles, ...

9 months ago
Not that this helps you, but the silver PLA that comes with ...

In forum Hardware, firmware and software help

9 months ago
Did you flash using the firmware provided by Bondtech? The B...

In forum User mods - OctoPrint, enclosures, nozzles, ...

9 months ago
I can't comment about clones - I don't buy them. I have been...

In forum User mods - OctoPrint, enclosures, nozzles, ...

10 months ago
The Mosquito is much better than the E3DV6 in my opinion. Mu...

In forum User mods - OctoPrint, enclosures, nozzles, ...

10 months ago
I really like the Mosquito (original) and find it to be far ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

10 months ago
May I suggest Guy Kuo's version of 3.8.1 at? It has support ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

10 months ago
@reddawg That's interesting, but not the issue here. The pro...

In forum Hardware, firmware and software help

11 months ago
It does, but there's a comment elsewhere that the actual val...

In forum Hardware, firmware and software help

11 months ago
The only way to adjust this is to use a custom firmware buil...

In forum Hardware, firmware and software help

11 months ago
My tubs routinely get to 10% with about 500g of silica gel.

In forum General discussion, announcements and releases

11 months ago
In my (few) experiments with it, I did not find I needed any...

In forum User mods - OctoPrint, enclosures, nozzles, ...

12 months ago
I do so from time to time, but I am confident enough that at...

In forum General discussion, announcements and releases

1 year ago
Bah. PLA and PETG sticks just fine to my Prusa textured shee...

In forum Hardware, firmware and software help

1 year ago
Reset the live Z to zero and try again. You'll then need to ...

In forum Hardware, firmware and software help

1 year ago
Images: Below the subject line is a button "Add Media". That...

In forum Hardware, firmware and software help

1 year ago
I used this yesterday and like it even better than the other...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Page 1 / 7
Share:

Please Login or Register