Activity
 
Notifications
Clear all
Marc
Marc
Group: Registered
Joined: 2019/02/28
Active Member
1
The multimeter that I have has a temperature probe (thermoco...

In forum General discussion, announcements and releases

2 years ago
@benjamin-g11, I'm suggesting that 235° really might not be ...

In forum General discussion, announcements and releases

2 years ago
Possible to disable long-press to adjust Z offset?

In forum Hardware, firmware and software help

2 years ago
I think that looks like underextrusion, but I have to admit ...

In forum General discussion, announcements and releases

2 years ago
That's a good suggestion, but I don't have any good referenc...

In forum General discussion, announcements and releases

2 years ago
I just measured the heat block with my multimeter (which sup...

In forum General discussion, announcements and releases

2 years ago
BTW, as a side comment, trying to do first layer calibration...

In forum General discussion, announcements and releases

2 years ago
I wanted to come back to this post with an update. I tried p...

In forum General discussion, announcements and releases

2 years ago
I don't think this is a translucent filament. Prusa's shop p...

In forum Assembly and first prints troubleshooting

2 years ago
Well, the spool was opened just fresh for these new prints f...

In forum Assembly and first prints troubleshooting

2 years ago
You still helped with a very useful base diagnostic issue wi...

In forum Assembly and first prints troubleshooting

2 years ago
Ah, thanks for letting me know! They show up for me, so I've...

In forum Assembly and first prints troubleshooting

2 years ago
Inconsistent color with Prusament PLA?

In forum Assembly and first prints troubleshooting

2 years ago
In my case, the textured sheet was already on the bed when I...

In forum General discussion, announcements and releases

2 years ago
Switching between print bed sheets

In forum General discussion, announcements and releases

2 years ago
I wonder what size inner-diameter the PTFE tube from the ext...

In forum General discussion, announcements and releases

2 years ago
Adding my two cents, I noticed similar issues with other fil...

In forum General discussion, announcements and releases

2 years ago
Share: