Notifications
Clear all
jason.s6
jason.s6
Group: Registered
Joined: 2016/11/26
Trusted Member
3
Were there any updates for this? I just started having the s...

In forum Hardware, firmware and software help

3 years ago
Were there any updates for this? I just started having the s...

In forum Hardware, firmware and software help

3 years ago
Were there any updates for this? I just started having the s...

In forum Hardware, firmware and software help

3 years ago
Were there any updates for this? I just started having the s...

In forum Hardware, firmware and software help

3 years ago
If that is the case would it be best to add M221 S100 in the...

In forum Others (Archive)

4 years ago
Id try setting your retraction distance to 0.8 mm, Retractio...

In forum Others (Archive)

4 years ago
From what I can see, they haven't' correctly the misalignmen...

In forum General discussion, announcements and releases

4 years ago
From what I can see, they haven't' correctly the misalignmen...

In forum General discussion, announcements and releases

4 years ago
Thank you so much! Upgraded today and no longer is my y belt...

In forum Others (Archive)

4 years ago
in 2 days I'll get few RJ4JP 01-08 IGUS bushings, will see i...

In forum How do I print this? (Printing help)

4 years ago
Is this 0,2mm layer? yeah 0.2 default MK3 profile from the...

In forum How do I print this? (Printing help)

4 years ago
Thanks Joe. Any chance the extrusion issue may also apply to...

In forum Others (Archive)

4 years ago
Sorry, but i'm really glad that i'm not alone. I have axactl...

In forum General discussion, announcements and releases

4 years ago
Here it is printed on its side. The rear side where the cool...

In forum How do I print this? (Printing help)

4 years ago
Wow, so jealous of your ring-free prints! I get ringing on p...

In forum How do I print this? (Printing help)

4 years ago
Wow, so jealous of your ring-free prints! I get ringing on p...

In forum How do I print this? (Printing help)

4 years ago
Well my rods and bearings arrived from Misumi this morning a...

In forum How do I print this? (Printing help)

4 years ago
Can I ask what the difference is between these two post proc...

In forum General discussion, announcements and releases

4 years ago
Well my rods and bearings arrived from Misumi this morning a...

In forum How do I print this? (Printing help)

4 years ago
Well my rods and bearings arrived from Misumi this morning a...

In forum How do I print this? (Printing help)

4 years ago
Page 1 / 3
Share: