Activity
 
Notifications
Clear all
tj
tj
Group: Registered
Joined: 2019/01/25
Trusted Member
3
the led mod can be very helpful, there is also a modificatio...

In forum General discussion, announcements and releases

1 year ago
i don't think testing it manually is going to be representat...

In forum General discussion, announcements and releases

1 year ago
2.5mm is larger than the filament size and i don't think it ...

In forum General discussion, announcements and releases

1 year ago
i was thinking about this a bit more and got an idea i haven...

In forum PrusaSlicer

1 year ago
Yes you need to do a TON of purging, any traces left even th...

In forum How do I print this? (Printing help)

1 year ago
You probably need to use more purging between the color chan...

In forum How do I print this? (Printing help)

1 year ago
What material are you using? flexible filament? if so make s...

In forum Assembly and first prints troubleshooting

1 year ago
you should not have to use a setting to make it work, especi...

In forum Hardware, firmware and software help

1 year ago
Not too long ago i ended up with a lot of unload issues and ...

In forum Hardware, firmware and software help

1 year ago
It is not clear to me what exactly is broken, can you includ...

In forum Assembly and first prints troubleshooting

1 year ago
Deliberately over extruding only infill?

In forum PrusaSlicer

1 year ago
What wire are you talking about? heater cartridge, temp sens...

In forum Assembly and first prints troubleshooting

1 year ago
It is not supported because is is very hard to get it workin...

In forum How do I print this? (Printing help)

1 year ago
Since latest versions of prusa slicer it should be pretty st...

In forum How do I print this? (Printing help)

1 year ago
For simplicity to slow print down, just turn the knob on the...

In forum How do I print this? (Printing help)

1 year ago
A couple of possibilities. Bad quality filament, i have had ...

In forum How do I print this? (Printing help)

1 year ago
Extrusions over air without anything below it will look stri...

In forum How do I print this? (Printing help)

1 year ago
a couple of things. have you cleaned your build plate so the...

In forum How do I print this? (Printing help)

1 year ago
@bobstro makes sense to have to adjust extrusion multiplier ...

In forum PrusaSlicer

1 year ago
Makes me wonder why you need different z offsets based on ma...

In forum PrusaSlicer

1 year ago
Page 1 / 5
Share: