Notifications
Clear all
yannick.m4
yannick.m4
Group: Registered
Joined: 2019/01/06
Eminent Member
2
Yet it is under advance under extrusion width => top soli...

In forum How do I print this? (Printing help)

1 year ago
Good to know but try my tip you won't be disappointed.

In forum How do I print this? (Printing help)

1 year ago
This is white ABS

In forum How do I print this? (Printing help)

1 year ago
Check this out. Perfect finish. Even with 45° angle 2020111...

In forum How do I print this? (Printing help)

1 year ago
Hi Robbert, Yes infill angle mathers but what will definit...

In forum How do I print this? (Printing help)

1 year ago
I dont remember honestly what was causing the issue. For sur...

In forum Hardware, firmware and software help

1 year ago
Picture from top  1582403420049.jpg

In forum How do I print this? (Printing help)

2 years ago
Gaps in walls

In forum How do I print this? (Printing help)

2 years ago
What is this defect ?

In forum How do I print this? (Printing help)

2 years ago
I cannot test it right now I am out of home for Christmas bu...

In forum Hardware, firmware and software help

2 years ago
Hello David, Thanks for your post. I actually only decreased...

In forum Hardware, firmware and software help

2 years ago
@bobstro Already done, I untightened the nozzle and tightene...

In forum Hardware, firmware and software help

2 years ago
@bobstro I have just tried what you explained and the extrud...

In forum Hardware, firmware and software help

2 years ago
@bobstro I tried to reduce speed in live by tuning it to 50%...

In forum Hardware, firmware and software help

2 years ago
Awful clicking noise from extruder

In forum Hardware, firmware and software help

2 years ago
Hello community, I have improve very well my top layers an...

In forum How do I print this? (Printing help)

2 years ago
X and Y printing size dimension too low

In forum Assembly and first prints troubleshooting

2 years ago
Here is the high quality picture Attachment removed

In forum How do I print this? (Printing help)

2 years ago
how to avoid those scars line on top surface

In forum How do I print this? (Printing help)

2 years ago
I had same problem and it cost me a lot to find the reason w...

In forum Others (Archive)

3 years ago
Page 1 / 2
Share: