Notifications
Clear all
Craig Trader
Craig Trader
Group: Registered
Joined: 2016/11/21
Eminent Member
2
Having a briefly read of some of the comments on this thread...

In forum Hardware, firmware and software help

4 years ago
Yesterday my power supply failed quietly. It was in the midd...

In forum Hardware, firmware and software help

4 years ago
Yesterday my power supply failed quietly. It was in the midd...

In forum Hardware, firmware and software help

4 years ago
This happened to me. It turned out that the PINDA probe was ...

In forum Others (Archive)

4 years ago
I recently read a FB post where someone stated that PR had i...

In forum Others (Archive)

4 years ago
Bhuwan Jain posted a comment on the "Happening Recently" tab...

In forum General discussion, announcements and releases

4 years ago
I baked the new drivers for windows with the tweaked setting...

In forum Others (Archive)

4 years ago
To be clear - I don't disagree on both points. Holiday time ...

In forum General discussion, announcements and releases

4 years ago
For almost all of the parts, you can print them in PLA as lo...

In forum Others (Archive)

4 years ago
For the benefit of those of us using Linux, will the print p...

In forum Others (Archive)

4 years ago
How positive are you that a left angle will make the power c...

In forum Others (Archive)

4 years ago
Just wondering if anyone knows what type of filament the 3D ...

In forum Others (Archive)

4 years ago
Trying to find out if the existing camera designs that clamp...

In forum Others (Archive)

4 years ago
1. I didn't see any mention of adding a Raspberry Pi Zero W ...

In forum Others (Archive)

4 years ago
I get good results from Inland PLA and PETG, the in-house br...

In forum Others (Archive)

4 years ago
it uses a miniature camera cable that isn't long enough to r...

In forum Others (Archive)

4 years ago
Based on past experience (ordering a MK2 kit last fall), kit...

In forum General discussion, announcements and releases

4 years ago
While the Original Prusa i3 MK3 is intended to be open sourc...

In forum Others (Archive)

4 years ago
I've been investigating what changes will be needed to make ...

In forum Others (Archive)

4 years ago
Can we expect the 3D design of the printer? Were they releas...

In forum Others (Archive)

4 years ago
Page 2 / 3
Share: