Notifications
Clear all
Craig Trader
Craig Trader
Group: Registered
Joined: 2016/11/21
Eminent Member
2
With OctoPrint, by default, it expects you to upload pre-sli...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Linux Drivers & Apps

In forum Hardware, firmware and software help

2 years ago
Keep in mind that PrusaConnect is evolved from the software ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Personally, I have two separate use cases: Octoprint at home...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
I would expect the biggest limitation would be with flexible...

In forum General discussion, announcements and releases

2 years ago
I ended up re-printing the tower and the cover using the lat...

In forum General discussion, announcements and releases

2 years ago
When doing the initial calibration, how am I supposed to mov...

In forum General discussion, announcements and releases

2 years ago
I had a working MK3 + MMU ... until I decided to do the MK3S...

In forum General discussion, announcements and releases

2 years ago
I would love to be able to upload my designs to either site ...

In forum General discussion, announcements and releases

3 years ago
You don't have to start a fire per se to create havoc. Park ...

In forum General discussion, announcements and releases

3 years ago
Thanks for the quick responses! - Craig -

In forum Hardware, firmware and software help

3 years ago
G-Code equivalents to menu actions

In forum Hardware, firmware and software help

3 years ago
You may want to consider disassembling the MMU2 and checking...

In forum Hardware, firmware and software help

3 years ago
There have been a lot of comments about how Prusa totally sc...

In forum General discussion, announcements and releases

3 years ago
[...] I'd like some profiles for the Mk3 that are at least a...

In forum General discussion, announcements and releases

3 years ago
I assume the reason is the "extrusion issue". Because so man...

In forum General discussion, announcements and releases

3 years ago
Note: This question has gone for more than a month without a...

In forum General discussion, announcements and releases

3 years ago
Speaking of thermal runaway, I was looking at the Prusa Mk3 ...

In forum Hardware, firmware and software help

4 years ago
The wiring harness is simple. Go to your home improvement s...

In forum Hardware, firmware and software help

4 years ago
I am waiting on my Mk3 to ship. Would you suggest not using...

In forum Hardware, firmware and software help

4 years ago
Page 1 / 3
Share: