Notifications
Clear all
Vojtěch
Vojtěch
Group: Registered
Joined: 2019/01/01
Honorable Member
1
Yes, the PTFE chamfer also explains the shapes better to me....

In forum Assembly and first prints troubleshooting

2 years ago
@nick-i3mk3s Where does the thick part of the removed filame...

In forum Assembly and first prints troubleshooting

2 years ago
But this is what Nick said: Posted by: Nick Tim, here is a p...

In forum Assembly and first prints troubleshooting

2 years ago
For the exact shape and dimensions, refer to Prusa's How to ...

In forum Assembly and first prints troubleshooting

2 years ago
Well yes, unless the whole hot-end was diassembled first. Wh...

In forum Assembly and first prints troubleshooting

2 years ago
My plan is a blob of thermally conductive paste. 🙂 But it'l...

In forum Assembly and first prints troubleshooting

2 years ago
Oh god, what is this monster? 🙂 This shouldn't be possible ...

In forum Assembly and first prints troubleshooting

2 years ago
You may have noticed that I also said that for me, the Noctu...

In forum Assembly and first prints troubleshooting

2 years ago
The voltage conversion is trivial, simply connecting the red...

In forum Assembly and first prints troubleshooting

2 years ago
It may require a bit of dialling in to find the best setting...

In forum Hardware, firmware and software help

2 years ago
Yes, it does. If you build a dry box, then the best next ste...

In forum How do I print this? (Printing help)

2 years ago
The reason is that no supports are required for this model. ...

In forum Hardware, firmware and software help

2 years ago
The E3D v6 on the Mk3 is an all-metal hot-end already. The o...

In forum How do I print this? (Printing help)

2 years ago
I have had success with the Sanyo SanAce B52 109BC24GC7-1 f...

In forum Assembly and first prints troubleshooting

2 years ago
So far I have only seen the term heat-creep used to refer to...

In forum Assembly and first prints troubleshooting

2 years ago
That doesn't match my understanding of cooling and heat-cree...

In forum Assembly and first prints troubleshooting

2 years ago
Yes, this should covered by warranty if you're still within ...

In forum Hardware, firmware and software help

2 years ago
Does this happen everytime you try to flash with the same re...

In forum Hardware, firmware and software help

2 years ago
.

In forum General discussion, announcements and releases

2 years ago
That's the correct spot for a permanent change. The values a...

In forum Hardware, firmware and software help

2 years ago
Page 2 / 32
Share: