Activity
 
Notifications
Clear all
KevinK
KevinK
Group: Registered
Joined: 2018/12/30
Trusted Member
3
I get those warnings all the time no matter what power suppl...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
Didn't see this above but might have missed it. I'd like to...

In forum General discussion, announcements and releases

8 months ago
@gglockner The only issue is melting/sagging over time. If ...

In forum Hardware, firmware and software help

9 months ago
Also check the tightness of the grub screw on the X axis ste...

In forum General discussion, announcements and releases

10 months ago
That picture of the filament roll looks like you have a cros...

In forum Assembly and first prints troubleshooting

12 months ago
I print screws/screw holes all the time in PETG. A few rand...

In forum How do I print this? (Printing help)

1 year ago
Nice job - I had done something similar for my pegboard base...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
@bobstro I also found the whole 10 limit confusing since cur...

In forum General discussion, announcements and releases

1 year ago
I can live (I think) with the 10 projects limit since I gene...

In forum General discussion, announcements and releases

1 year ago
I find that I can print out angling walls at quite a bit ste...

In forum How do I print this? (Printing help)

1 year ago
I pretty much always do tests for this as well. It was actu...

In forum Hardware, firmware and software help

1 year ago
Exactly where does PrusaSlicer place filament traces (hole c...

In forum Hardware, firmware and software help

1 year ago
I never use the preheat option, precisely because it doesn't...

In forum General discussion, announcements and releases

1 year ago
Also - check the grub screws on the extruder for the X axis....

In forum Assembly and first prints troubleshooting

2 years ago
Looks like you are getting multiple layer shifts. First thi...

In forum How do I print this? (Printing help)

2 years ago
I suspect that you are seeing elephant's foot compensation. ...

In forum PrusaSlicer

2 years ago
I second Fusion 360 for functional stuff. Incredibly powerf...

In forum General discussion, announcements and releases

2 years ago
Thanks - didn't know if setting to 0 would disable. Pretty ...

In forum PrusaSlicer

2 years ago
@bob-h9 That single line (I think it actually defaults to 3 ...

In forum PrusaSlicer

2 years ago
I searched the github issue for reference to it and didn't f...

In forum PrusaSlicer

2 years ago
Page 1 / 3
Share: