Notifications
Clear all
Strankler
Strankler
Group: Registered
Joined: 2018/12/26
Active Member
1
Update: Since Firmware Version 4.0.3 the bed temperature won...

In forum General discussion, announcements and releases

1 year ago
We had this problem, too. No only once. Also, a lot of other...

In forum Hardware, firmware and software help

1 year ago
@littleneutrino I just wanted to post my settings here, sinc...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
4.0.3 is officially released and verified by PR. No need to ...

In forum General discussion, announcements and releases

1 year ago
Even if we are getting off topic, OctoPrint still works with...

In forum General discussion, announcements and releases

1 year ago
I use to put some talcum powder (baby powder) on the PEI, wh...

In forum General discussion, announcements and releases

1 year ago
Hi Folks, short update on this topic: First off all, tha...

In forum Assembly and first prints troubleshooting

1 year ago
Thanks guys. This is truly helpful for everyone, who will de...

In forum General discussion, announcements and releases

2 years ago
Selftest Wizard - Z-Axis

In forum Assembly and first prints troubleshooting

2 years ago
Did anyone already installed the R2 parts? Especially for th...

In forum General discussion, announcements and releases

2 years ago
When I look into my orders, newest stauts is always on top,...

In forum General discussion, announcements and releases

2 years ago
Possibly, but on the other hand, the next black one w/o sens...

In forum General discussion, announcements and releases

2 years ago
Not trolling, just ordered a black one w/o sensor eary enoug...

In forum General discussion, announcements and releases

2 years ago
Share: