Marc
Group: Registered
Joined: 2018/12/25
Active Member
1
|
Thank you Tim. In following your advice to lower the PIND... In forum Original Prusa i3 MK3 & MK3S & MK3S+ |
4 months ago | |
|
PINDA Setup question In forum Original Prusa i3 MK3 & MK3S & MK3S+ |
4 months ago | |
| @neophyl WOW thanks! I just checked the print, and guess wha... | 4 months ago | |
| Blobs of melted filament are fouling my print and causing cr... | 4 months ago | |
|
@chocki I just changed out my Y axis bearings with PRUSA ori... In forum Hardware, firmware and software help |
10 months ago |